 What's
included:
This 10 pack is ready to run as packaged but additional parts are
included to allow you to customize your RoadRailer system train. Nine
of the RoadRailer trailers in the package are configured like the
upper one in the picture on the left. The tenth RoadRailer trailer
is equipped with a CouplerMate on the front like the lower model in
the same picture. Also
included are ten of each of the three following parts sprues:
1. The Three
Coupler Tongues. On the left is the "front  CouplerMate
tongue." See the CouplerMate instructions for more on this piece.
In the center is the "decorative tongue" for use while your RoadRailers
are in highway service or parked around the terminal area. The tongue
on the right is use if you are modeling a standard non-RoadRailer
trailer. In theory this tongue can also be used in a RoadRailer system
train but it would require huge minimum radius curves and is not recommended
for this use. A fourth tongue is already installed on the RoadRailers
and it is this tongue  that
is used in standard rail service. 2.
Bumpers and Landing Gear. From left to right, the first two items
are the bumpers for the back of the trailer. The upper one is for
highway service and the lower is for rail service. See the section
on bumper placement for more information. The second pair of items
are the landing gear legs. The longer ones are for parking the trailer
on the ground while the shorter |
|
|
RoadRailer,
RoadRailer Trailer, RoadRailer System, CouplerMate, and RoadRailer
Bogey are all trademarks of the Wabash National Tecnology Corporation
and used by permission of the Wabash National Corporation
|
|