Containers that will fit the wells include: Lower position: deLuxe innovations 20 foot, Roco 20 foot, deLuxe innovations 40 foot reefer, deLuxe innovations 40 foot corrugated  dry box, MicroTrains rib side dry box, Walthers Hi Cube corrugated dry box, and Roco 40 foot smoothside. Upper Position: deLuxe innovations 48 foot reefer, deLuxe innovations 48 foot Monon smoothside, Walthers 48 foot Stoughton rib side, ConCor 48 foot rivet side, deLuxe innovations 40 foot reefer,  deLuxe innovations 40 foot corrugated dry box, MicroTrains 40 foot rib side dry box, Walthers 40 foot Hi Cube corrugated dry box, and Roco 40 foot smoothside. There are some older prototypes that are out of scale. DO NOT try to force these containers in to the car, as the car will split. The lower well of the car is a tight fit for scale containers. The outsize boxes will split the sides of the car and cause permanent damage. Containers can be firmly installed and removed over and over again by using deLuxe innovations Container Glue. Roll up a tiny snake and place it in the ribs on the bottom of the container, press it firmly into the top of the next container, and it will  hold it's position without damage or marking until you move it. This gummy substance has been tested on all kinds of containers and does not remove or mark paint that has been properly applied. Container Glue can be used on all brands of well cars, and is great for routing simulations and loads out/ empties back operating schemes.
|
||||
|
CSX prototype twin stack |
||||